Superwinch Rocker Switch (2233B) User Manual download pdf

Disconnect the black and red switch power leads at the

battery. Cut the red and black switch leads close to the

strain relief at the switch. Strip each cut end 1/4-inch.

Crimp a quick disconnect terminal onto the stripped

end of each switch lead. Remove the red or blue and

black or yellow motor leads from the rear of the switch

bracket. Cut off the ring terminals from each lead.

Strip each cut end 1/4 inch. Crimp a quick disconnect

terminal onto the stripped end of each motor lead.

Remove and discard the old switch and bracket.

Refer to the figure for wiring diagram.

Wire terminals must be properly

installed on the switch. Improper

installation will result in high

resistance connections that

could lead to excessive heat.

Installation Instructions for Rocker Switch Retrofit Kit P/N 2233B

Contents:

Installation:

87-10928 Rev - 11/12/04

Description Qty

Rocker Switch 1

Switch Mounting Box 1

Mounting Bracket and Hardware Kit 1

1/4-inch Quick Disconnect terminal 4

Split Loom Tubing 2

Sealed Circuit Breaker 1

Battery Connection Wire 1

Terminal Boots 2

1 To Motor Yellow

2 red to battery (+)

4 black to battery (–)

3 To Motor Blue

WARNING

1 To Motor Yellow

2 red to battery (+)

2 Red

4 black to battery (–)

4 Black

3 To Motor Blue

3 Blue

1 Yellow

+ BAT

Note: This kit is designed specifically

for Superwinch 2.5 inch motors.

1 2 3 4 5 6

Summary of Contents

Page 1 - Installation:

Disconnect the black and red switch power leads at thebattery. Cut the red and black switch leads close to thestrain relief at the switch. Strip each

Page 2 - ROPE OUT

Hole pattern in switch box mounting bracket allows switch box mounting in any one of severalpositions and orientations. Always use both box combinatio

Page 3 - Instalación:

Instrucciones de instalación para el juego de retroadaptación deinterruptor de balancín Nº de pieza 2233BContenido:Instalación:Desconecte los conducto

Page 4 - ADVERTENCIA

El patron de orificos en el soporte de montaje de la caja del interruptor permite el montaje de la caja delinterruptor en una de las varias posicione

Page 5 - Installation :

Consignes d’installation - Kit d’actualisation du commutateurà bascule - No. de pièce 2233BContenido:Installation :Déconnectez de la batterie les fils

Page 6 - ATTENTION

Le dessin des orifices indiqué dans le support de montage du carter du commutateur permet de monter le carter ducommutateur dans l'une quelconque